Production process



After being pulled off, the raw hide must be protected from bacteria that generate its decomposition. Both sides of the hide are well salted because salt prevents any decomposition. The preservation process causes dehydration.


When raw hides arrive in the tannery, they are loaded in drums with water to remove the salt used for preservation, any blood or dung rests and any micro-organisms. The hide is now rehydrated and clean and must now pass to hair removal process called “liming”.

Liming process

At this stage the hair and the epidermis are removed chemically by using a solution of lime (calcium hydroxide) and sodium sulphide.


The flesh side of the hide is cleaned from the grease and the flesh left after flaying.


Thanks to this mechanical operation, the hide is divided in different sections: the grain – the upper side of the hide – is divided from the split, the lower part of the hide.

Mineral tanning

This process aims at giving a strong stabilisation to the hide, it is usually performed with basic trivalent chrome sulphate, a mineral salt that penetrates the hide, and it lasts about 24 hours. At the end of this stage, the hide looks blue/dark green (most commonly used tanning).



This operation is performed to remove all exceeding water and smooth the hide.


With this operation the hide is shaved and gets a uniform thickness all over its surface.

Dressing and Deying

Hides are dyed in drums with water and dyes, anti-mould agents and re-tanning products, fat substances able to achieve the required color and softness.


The hide is dried in a vacuum system consisting of steel plates that suck out water through vacuum depression, otherwise it is dried in the air: it is hung onto a chain to get conditioned at room temperature.



The hide is smoothed and softened by means of a machine operating a mechanical beating.

Dry milling

The hide is further softened by mechanical shaking in drums.


The hide surface is slightly rubbed with emery paper to remove small imperfections.


The hide is given the desired final color and touch.


This operation is performed to give the hide the brightness required.


This operation is performed to give the final product uniform and precise edging.

Final selection

The hides are carefully inspected and selected according to their quality and surface appearance.


The hides are measured with electronic machines. Since leather is an elastic material, it is subject to a natural loss and therefore a measuring tolerance of 2 to 3% is accepted according to the international rules.

18 magazzino